FORUM ARTICLES SEARCH
Home > Forum > General > Family Tree Maker: Printing and Formatting Trees, Charts, and Reports

Re: Editing Register reports

By Barbara Mclean March 27, 2011 at 02:16:24
  • In reply to: Re: Editing Register reports
    H R Worthington 3/27/11

I am sorry but I don't think you understand my problem.
I am not good at communication on paper.

In ver 16 and all prior versions I could edit the report as RTF.(I have no problem with RTF and have used word processors as an occupation) In ver 2008, it seems as each page of the generated report is stamped in stone as far as pages go.

EG. If I deleted the first paragraph in this post, the 2nd paragraph would roll up and take its place.However, in ver 2008 a blank space would takes its place instead of the following paragraph.

Hopfully, someone out there will recognize what I am saying and tell me if i would have the same problem with 2011.

In the meantime, If I need to print, I can export to a GED and open it in ver 16 and then export the report to RTF, and edit to my hears content.

Barbara













comments powered by Disqus

More Replies:

  • Re: Editing Register reports
    Norris Taylor 3/27/11
    • Re: Editing Register reports
      Barbara Mclean 3/27/11
      • Re: Editing Register reports
        H R Worthington 4/01/11
        • Re: Editing Register reports
          Barbara Mclean 4/01/11
          • Re: Editing Register reports
            H R Worthington 4/01/11
  • Re: Editing Register reports
    H R Worthington 3/27/11
Sitemap Terms Privacy FAQ
© 2018 Genealogy.com