Woe is me....... I had a missing dll and took my computer to "Best Buy" to have Windows restored and have them back up my two hard drives.I told them my biggest concern was my 25 years of Genealogy data.No problem, they said, as they would back-up everything.To make a long story short.....they only backed up my D drive.UFT and much more important data was on C drive.So sorry, they said.
Can anyone tell me what files should be Archived and Read Only.I just copied my UFT (that I had luckly copied to a CD) to my D drive. I could not open any of my projects and thankfully I read on this board that you should look to see if project files are "read only", which they were. I can now bring up my project but "Place missing from Library" is shown in event place.I see here that these files in the Library should not be checked "Read Only".I will un-check these...but want to know if any of the other files should be Read Only or Archived, etc. When and if I get all this running again...... I am going to look into getting different genealogy software.